Help with iu conversions - daily subQ

[n3rd]

I have a blend 100mg of tren e, mast e, and test e @ 1mL
I want to run this next cycle subQ daily.

For the life of me, I’m having a hard time with the conversions.
is 3iu = to 30mg?
Meaning if i took 3iu daily, that would equate to 210mg a week?

How do you simplify this conversation process?

 

[Mossy1985]

The third mark is actually 30iu. But you’re correct sir. I believe there’s 100iu per ml.

 

[NeuroRN]

It depends on your insulin pin. If it’s 100iu per Ml. That is correct.

 

[TBU]

Most Slin pins are listed 0 -100 for 1ml pins and 0-50 for 1/2nl pins. 100 on the Slin pin would equal 100mg if the bottle is 100mg per ml. So 30 on the pin would equal 30mg. Now listing as IUs for example let say you have a bottle of HgH mark as 10IUs. You put 1ml of BAC water in it 30 on the needle would equal 3IUs. I hope I didn’t make that too hard… also there is some conversion chart on the web and I’m trying to find the link. It will tell you dosing for any type injection. I’ll try and find it

 

[n3rd]

@NeuroRN , @TBU @Mossy1985 -
Thanks guys!
I think I’m give this a go, see how well it works.

 

[n3rd]

Are you fighting the oil in to the syringe?
Takes way to long to draw 3iu… almost to the point I’d rather just go back to IM…

 

[Ominous]

Sub Q with oils from what I have seen most using 29g and 1/2”.
Or 27g 1/2”
But curious on what size you are using ?

 

[TBU]

What @Ominous said… what gauge are you using?

 

[Dirtnasty]

Could always back load as well

 

[n3rd]

Using 32g x 8mm… lol.
A bit of difference from what you’re saying…

 

[n3rd]

Backload?
I’m guessing you’re saying load up a few syringes to last a few days?

 

[Ominous]

Yeah the oil is a bit thick for that gauge.
29 or 27 is what I see most using. I would warm it up and see if that helps. If not then try the 29 gauge.

 

[Dirtnasty]

I meant take out plunger and fill from behind with a drawing syringe

 

[n3rd]

I’ll give both of those ideas a try.
Thanks guys! @Ominous @Dirtnasty

 

[Rusty]

I heard some guys put in hot tap water to make oil thinner. But I have never done it might want to find out temp range oil is allowed to be at.

 

[TBU]

32 gauge? Holy shit!! That would take Years! 28g is slow. But doable. I bought separate needles a couple weeks later and got 27g 1/2” for barrels. Warm the oil, works pretty well.

 

[TBU]

I use warm water. You can use a heating pad too. I just warm it to the touch, and it is painless and zero pip.

 

[TBU]

Back loading works for stacks too. Keep the oils from mixing and get exact dosing in the barrel.

 

[Dirtnasty]

I’ve never thought of that

 

[TBU]

When I say mixing, I mean drawing from one bottle than the other mixing. I just wanted to make that clear.