Steroidify
Napsgear - The Largest and Most Trusted
Purity Source Labs
Your Muscle Shop
GearChurch
Platinum Pharmaceuticals
Omega
Savage Labs
Geneza Pharmaceuticals
Ask an IFBB Pro
MusclePay
BulkoLabs

Possible Contimation

Swest

Swest

Well-known member
image


Not sure if the photo is clear but I was checking my test before pinning tonight and found four little specs of something at the bottom of the bottle. As this was one of two I check the other one and fortunately it’s clear (and I’ve binned this one).
All my bottles are stored upright, out of sunlight to avoid degradation of the rubber- is it possible that I’ve caused this when drawing or should I speak to the source? They are a sponsor on here but I’m not going to name them as I’m not sure if it was caused by me. Any input would be appreciated.
 
It shouldn’t really be falling apart with 25g unless you are being rough with them when you draw.
Do you also put air into the vial to replace the amount of oil your going to pull out?
This will release the pressure on the stopper and you won’t have this issue anymore
Hopefully
 
Last edited:
Yeah I always push a slightly high volume of air than I want to draw. There was only about 1ml left when I noticed this so binning it is not the end of the world (and I’m pretty sure I haven’t pinned myself with rubber debris).
I’ve started the new bottle so will see how that one goes. If the same thing happens I’ll speak with sponsor.
 
Thinking about it- I use a 23. I pin with 25’s
I’ve never had it before so I’m going to draw with 25’s on the new bottle and see how it goes. I always warm the oil first so should be ok.
 
Yea brotha like @Bigmurph mentioned I would put my money on the stopper being the issue. Trust me if you pinned yourself with rubber debris you would have had some issues by now. If that’s the end of the vial and you have others on han then just don’t risk it man, I mean you could keep a close eye on it and draw with a slin pin, but like I said not worth it. If your other vials look good and clear then just trash that one
 
Last edited:
I pull with 18’s and always hit the same hole. I used to have issues with pieces of rubber contaminating my stuff, I may have even shot a couple on accident, but since I stopped moving my pin around in the stopper, it hasn’t been an issue.
 
Back
Top