Wiping Vial Before Drawing

Status
Not open for further replies.

Ags43z

Well-known member
I want to get peoples opinions here as I have a tendency to be overly cautious. A couple of months ago when I was testing the gear I’m currently using, I drew from a new vial without wiping it with alcohol to use it for roid test. I didn’t think about it since I wouldn’t be pinning it but then I had some left in the pin so I stuck it back in the vial to use later. It then donned on me that I never cleaned the stopper either time I stuck the pin into it. Would you guys still use this or could I be exposing myself to bacteria since I never sanitized it?
 
I’m going to give you a “bad” example. I ran out of preps. No ability to get any. Just took a shower before I pinned. About 8 times. New draw and pinning needles and barrels is the most import thing to have. Now. Would I recommend doing it? No. But I didn’t have any issues. I think you’d be fine if the needles were clean. Shit in the military they swab you down once then you get 4 or 5 shots so there is that. Hell, I got tattoos in a clubhouse in the 80s…. 😳
 
I never clean anything with alcohol. I figure the benezole alcohol in the vial will kill any bacteria that gets in it,

If you’re real paranoid you could always heat it to 120 degrees F for 20 minutes to pasteurize it.
 
Last edited:
Status
Not open for further replies.
Back
Top