Gingerlifter and his DHB cycle log

Thanks for sharing @Gingerlifter. Those are pretty low test numbers at 420mg/WK of testosterone. I would be expecting 1800ng/dL or higher on properly dosed testosterone.
 
Last edited:
Whoa!!! 420 a week and you’re only at 1354ng?! That’s super low bro. Averages I see are around 5x the dosage. You should be closer to 2200ng bro.
 
My guy right now is running 400 a week and is at 2,080ng which is exactly 5.2x the dosage which is where I would expect most people to be if the test was dosed properly. The lowest I’ve ever calculated is 4.8x the dosage and that’s still within a respectable range for a UGL
 
Typically 48hrs is the norm for most tests. If it was about 96 hours we might see it that low.

I should note that the ester plays a part in that. Longer esters like enanthate or Cyp is 48 hours. If it were prop, ace or phenyl prop 24 hours.
 
Last edited:
Agreed. 96 is pushing the half life of enanthate but a 30% loss at 96 hours would still make me question the dosing from the brewer
 
Remember serum levels are peaked because of the length of time on cycle so the drop off is going to be slow. It’s not like a light switch.
 
Last edited:
And I believe my calculations are correct. Test 300 and I’m drawing up .7 test per pin plus .8 of the dhb. In any case 1300 is still ok. It’s probably a bit underdosed I suppose but in any case I wont be ordering anymore from him whom shall not be named!
 
Back
Top